How to read this
Height is voltage. The floor is the reference node, 0 V. Every wire of a node sits at that node's voltage, so a wire is level and voltage changes only across elements. Walk any loop and you come back to the height you started at: that is Kirchhoff's voltage law. Wires below the floor are at negative voltage.
Ramps and steps. Resistors and inductors are ramps: the drop is spread along the element. A capacitor's plates each sit at their own node's height, so its voltage shows as a step across the gap. A source is a pump, a pipe that lifts charge from its − terminal up to its + terminal.
Ribbons are current. A ribbon hangs under every path that carries current. Its depth is the size of the current, and the arrows on top show which way it flows (conventional current). At a junction, the ribbons going in add up to the ribbons coming out: Kirchhoff's current law. Across a capacitor the ribbon turns faint, because no charge crosses the gap; it piles up on one plate as it leaves the other.
Energy and power. Columns beside the capacitor and the inductor rise with the energy each one stores (½Cv² and ½Li²). Resistors glow with the power they turn into heat. The energy plot stacks the heat dissipated since t = 0 under the energy stored; the dashed line is what the circuit started with plus what the source has put in, and the stack always meets it.
The water picture, and its limits. Height as pressure and current as flow make a resistor a sloped channel, a source a pump, a capacitor a tank and an inductor a heavy wheel that keeps the water moving. It breaks down in places: charge does not fall under gravity, the ribbons do not mean charge is used up, and a capacitor is not open to the air. Use the picture for intuition and the equations for numbers.
Controls. Drag to orbit, scroll to zoom (Ctrl/⌘ + scroll when this page is embedded), hover anything for its values, and drag on the plots to scrub time. Every value box takes typed numbers; the ⋯ button sets a slider's range and switches it between linear and log.
What's new here. Height for voltage, ramped elements, ribbons for current with arrows for direction, and animation in time all follow the original paper. The energy columns, heat glow, energy bookkeeping, moving arrows, synchronized plots and the build-up animation are additions in this version. The simulation is a small built-in circuit solver (modified nodal analysis with the trapezoidal rule), checked against the textbook closed-form responses.
Based on E. R. Doering, “CircuitViz: a new method for visualizing the dynamic behavior of electric circuits,” IEEE Transactions on Education, vol. 39, no. 3, pp. 297–303, Aug. 1996.